Noctua Redux and IndustrialPPC Fans

IndustrialPPC Fans, a Closer Look

Cracking the carton you’ll find a beautiful black fan in each box with the cord tucked under the spacer around the edge of the fan.

 

Both models of the IndustrialPPC fans come with the lone accessory set of four mounting screws. Cable length for the power hook-up is sixteen inches and is coated in a high quality rubberized sleeve with heat shrink at both ends.

 

On the backside of the fans, you’ll find Noctua’s label with the fan model and electrical ratings.

Not shying complete away from their trademark brown, the IndustrialPPC fans have a brown rubber anti-vibration insert at each corner.

These inserts are easily removed as they are held in place by two guide pins and a lip that slips over the edge of the fan.

 

The IndustrialPPC fans are quite rugged, featuring fiber glass reinforced polyamide construction. What exactly does that mean? In my case, it means a 230 pound man can walk all over these fans with no consequence. A few months ago, I had a 140mm case fan that was on my bedroom floor as a result of a case dismantle (a bad place for a fan to be). I wasn’t paying attention, stepped, SNAP, and there went a corner bracket on the fan. For kicks I tried this with the IndustrialPPC fans but to no avail, the fan housings held firm.

 

About noobas4urus

9 thoughts on “Noctua Redux and IndustrialPPC Fans

  1. A fan and some screws in a box….at that price?!? They better blow everything else, not only clean out of the water, more like straight into the next state, to deserve 5 bright&ripe bananas! IMHO (lol)
     
    Kudos to Noctua tho for finally daring to go beyond their trusted design! (wich, if we are to be honest about it, may not have appealed to everyone, but certainly also has lots of fans (see what i did there). Design as well as pure performance has served Noctua extremely well for so many years.

  2. Pricing isn’t bad considering the defacto GT AP fans were going for as much or more.  IF these perform anything like the old GT AP fans, then it’s a no-brainer.

  3. I’ve acquired a pair of the NF-F12 IndustrialPPC 2000RPM IP67 PWM’s for my Mothball rehash, we’ll see how they fair on the new ***** AIO (it’s a secret lol).

  4. wanting to try these out from when i heard about them. I have just the perfect case build for them…Good solid review Stu a tonne of work.. cheers for the rundown…

Leave a Reply

Your email address will not be published.