Search the Community
Showing results for tags 'k.3nny'.
Found 2 results
New build new changes Thnks to NZXT HQ for this case: NZXT Phantom 820 Gunmetal. Gonna strip it down, tear it up and design and build a better one in my style. Originally Stock, It isnt my style, to futuristic, Gonna flip it all over,go the clean route and Do my thing. Flipped motherboard I/O is on the upper now. I need a clean top panel now, gonna leave only the mesh part stock, the rest will be cleaned See u with the next update
Time to explain how to make acrylic tubing * my english is not THAT good!!!! First of al, search and use object for the bends, i prefer steel, it keeps the heat stuck, and doesnt cool down your acrylic pipe that quick. Always make the tube longer than u need!, the bends can not come out how u want sometimes (weakspots) I use a Power suply 7mm thick cord (EU) I prefer a hairdryer, because u cannot overheat the tube and it wont make it to warm so you pull the tube flat. If the tube is hot enough, u cant start bending the pipe, dont pull to hard otherwise u get a flat spot at the end of the pipe. If u are at the point that your tubing is bend and lined up with the fittings u can cut it to size I used a cheapo rotary tool and a dremel atachment (sanding barrel P120) My working situation xD! Tape it 7/8mm of the edge, so you know you dont get an ugly spot above your fitting only sand the tube till its frosted! dont use pressure, dont create flatspots, the pipe is sold as 12mm but the exact size is 12.3/12.7! so yes just a little touch all around is enough! finish it up with sandpaper Grid P400 so the rubber ring wil fit nicely! Test the fitting