Search the Community
Showing results for tags 'pentium 4'.
Found 1 result
Introducing: 1200 or Butts! I bought this case on PimpRig.com for 1$ + shipping roughly 15 years ago: It's an AT! (even came with a keyboard with that giant connector...) This was home to my primary rig throughout high school, running a Pentium 4 2.4C. I put a lot of work into it back in the day, but it has clearly seen better days. (It definitely served as home to some small creatures at one point.) I've kept it around all these years with the hopes of one day realizing some of the mods I once hoped to make, and the time has finally come to revisit my old friend. The mice left it quite filthy, so first it's time to take it all apart and scrub the whole thing clean. What in the heck is that?! It's Silly Putty! ...apparently? I completely forgot about this one. I must have decided to use it to hold some posts in place. Those posts where annoying, but necessary because the corners lacked structural integrity (resulting in some cracking). Might have to to do something about that. How about some more putty! A decent helping of epoxy putty really helped firm up the corners. it feels nice and rigid when mounted, even without those pesky posts. And since I already have the putty out... Might as well use it to mount some standoffs. Not the most elegant solution, but it felt like the right move. I already had holes drilled, but I used to use bolts with a stack of nuts to mount the motherboard, and it was a giant pain in the ass every time. Now it'll much be easier to fill with goodies! (Like that classic Noisetaker II.) Speaking of which: Goodies! So what did I decide to power this guy with? A Pentium 2.4C of course! Why revisit this CPU of yesteryear? To pursue that elusive, legendary overclock that haunted my dreams or course! 3.6Ghz with a 1200Mhz FSB! Can it be done? I will find out, or die trying. I paired it with an Abit IC7-G, the board I always wanted and couldn't afford, and four 1GB sticks Corsair XMS DDR400. The IC7 should give me a decent first shot at 1200. The graphics card picured is a GeForce 4 MX 440, a temporary card obtained to ensure the 7800GS I have is non-functional. A replacement is on the way! The heatsink is a Thermalright XP-90 I found brand new on Amazon (grabbed a Noctua while I was at it). I thought cable routing would be a nightmare, but I remembered some old tricks. Without IDE, a build in this case has never felt so clean! So what plans do I have in store? I need to fab a back panel, and do some general cleaning up. (That extra square corner where I chopped off the drive cage drives me nuts!) The front bezel needs some cracks filled, and the switch area patched and cleared for new power buttons. To get where I'm going, water cooling is going to be a must! So I'm hoping I will be able to track down a DangerDen TDX, chipset, and GPU cooler (an NV78, or modded NV68?). If anybody here knows where to find some old DD parts, please let me know! For paint there is one thing I know for sure: beige and black, but paint will have to wait until spring. I was thinking about painting the chassis, but now that it's cleaned up a bit, the dingy corroded steel is is growing on me... Is it just me, or does that 80mm bracket on the front just scream pump/res mount? Most of the bottom will have to go to make room for a radiator. (Gonna need new feet!) Squeezing a 360 in there will be tight, but I think it should fit. Dusting this thing off has made me so happy, and made dragging it around for so long well worth it. There is just one destination: 1200 or butts! P.S. Since I'm digging up one relic, I thought I'd dig up another: